Resurfacing a pool in Kissimmee is not as simple as draining it and rolling on a fresh coat. Between our 78% summer humidity, near-daily afternoon storms from June through September, and a high water table that can literally float an empty pool out of the ground, timing and technique matter enormously here. Homeowners from Winter Garden to Lake Buena Vista are often surprised by how much planning goes into a job that looks straightforward from the deck. Here is the full sequence.
Most Kissimmee pool resurfacing projects take 7 to 14 days from draining to refilling. The work moves through draining, chip-out and prep, structural repair, tile and surface application, then a careful refill and 28-day water-chemistry break-in period that is critical in Florida heat.
The job starts by draining the pool, but in Osceola County we never drain without checking the hydrostatic relief valve first. Our water table is high and seasonal rain keeps it that way, so an empty shell sitting over saturated sandy soil can crack or pop upward. We schedule drains during drier stretches when possible and keep the pool empty for the shortest window we safely can. This is one of the biggest differences between Florida resurfacing and the same job in a dry climate. Owners in Lake Buena Vista near the lakes see the highest groundwater pressure.
Next we remove the old, failed finish down to a sound surface. This is where hidden problems appear: hollow delaminated plaster, calcium nodules from Kissimmee’s hard groundwater, and hairline cracks from soil movement. We bond-coat the shell, patch any structural issues, and replace waterline tile if needed. Skipping proper prep is the number one reason a resurface fails early. If your finish is already showing the warning signs we cover in our guide to when a Kissimmee pool needs resurfacing, the chip-out usually confirms it.
The new plaster, quartz, or pebble finish is troweled on in a continuous pour, typically a single day of intense work. The pool is then refilled immediately and continuously, because letting fresh plaster dry out in our sun causes shrinkage cracks. A 15,000-gallon pool can take 12 to 24 hours to fill. Then comes the part many homeowners underestimate: the break-in. For the first 28 days the finish is curing, and daily brushing plus tight chemistry control protect the new surface. Customers in Winter Garden and Hunters Creek get a written break-in schedule.
We sequence every project around Kissimmee’s weather and soil rather than a generic checklist. That means watching the forecast before draining, never leaving a shell empty over a saturated water table longer than necessary, and refilling immediately after application so the finish cures evenly. Our crews handle the full chain, from hydrostatic checks to the 28-day break-in coaching, so you are not left guessing about chemistry during the most fragile stage. Contact us through our service area pages to get a realistic timeline for your specific pool.
Plan on 7 to 14 days from drain to refill for most residential pools, with weather and structural repairs being the main variables that can extend the window.
Light rain after refill is fine, but heavy storms during the open-shell or fresh-application stage can damage the finish, so we schedule those steps around Kissimmee’s afternoon storm pattern.
Fresh plaster and pebble finishes must stay wet to cure properly. In Florida sun, an exposed finish can shrink and crack within hours, so continuous refilling is essential.
It is the curing window where the new surface hardens. Daily brushing and careful water balance during these four weeks prevent staining, scaling, and surface defects.
Fill out the form and our team will get back to you quickly.